Peumatic Grouting pump is designed for stress and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes to have the ability to reinforce the loose rock mass. The maximum grain size can not exceed zero.2 mm.
Grouting pump operation and upkeep is easy, protected and dependable. This pump is used in mines operating underneath difficult conditions as a outcome of it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump include: An air inlet, the pneumatic cylinder, mounting base frame and stand, strain gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it works
Pneumatic stress in the air cylinder exerts a excessive stress on the grout combination which ends up in ejection of grout with a high stress and velocity. The valves of the air cylinder in the pump operate mechanically to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to finish the pumping cycle.
Pneumatic grout pump can be driven even without Electrical energy provide in remote areas through the use of engine driven compressor.
The pump is majorly utilized in development and mining business for injecting materials into broad and medium size hole in beams, columns ,basement partitions and flooring, lift shaft concrete wall fill-up and so on. In mining business it is used to replenish cement solution the place there is a gap exists between construction and rock and for soil stabilization.
Detachable design tends to straightforward upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is broadly used in tunnels, coal mine, bridges and dams, building foundation, and other underground initiatives, and inflammable, explosive websites and different unhealthy surroundings.
It has application in chemical industry additionally to pump out chemical slurries.
The pump is electrical energy free so, can be used at any website situation whether or not it’s rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment range. Generally the ultimate quantity of the grouting volume is eight or10 occasions of the quantity at first. And the ultimate grouting quantity proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s stress and circulate can be adjusted according to the necessities of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).apart from, This Pneumatic high-pressure grouting pump can be used for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electrical energy, development, mining etc. ground/underground building.
Mining Pneumatic Grouting pump has the benefits of low energy consumption, small vibration, low noise, small measurement, excessive effectivity, dependable performance, pressure and circulate control, long life and so on. Common mine grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can also be Light weight and with a wheelie design it could be carried simply. ที่วัดแรงดันน้ำ is designed for easy operation and low maintenance. Last however not least its spare parts are easily out there.